top of page
Search

Replacing the old toggle orange switch with the new LED push-button switch. Step-by-step guide.

Oct 28
2 min read

Replacing the old orange toggle switch with the new E-023 12V green LED push-button switch? Follow the six steps below, or download the printable installation guide with its wiring diagram.



Before you start


Turn the sprayer off and remove the battery before opening the base or disconnecting any wiring. Confirm that the replacement switch and wiring diagram match your sprayer before making connections.


Have the new switch, a 3–4-foot pull string or pull wire, and a small amount of silicone adhesive ready.


1. Disconnect the old switch wires


Disconnect the two switch wires inside the base.


2. Attach a pull string


Securely attach a 3–4-foot length of string or pull wire to the disconnected switch wires. This will be used to guide the new wires through the handle.


3. Remove the toggle switch


Pull the old switch, wires and attached string out of the handle. Do not pull the string completely out. Leave string at both ends, then detach the old wires. Remove the black plastic switch-to-handle adapter; the new switch does not need it.


4. Pull the new wires through


Securely attach all four new switch wires to the string. Gently pull from the base end to guide the wires down the handle. Remove the string once the wires are through.


5. Secure the new switch


Apply a small amount of silicone adhesive to help hold the switch in place. Keep adhesive away from the button mechanism and electrical connections.


6. Connect the new switch


Connect the four wires according to the wiring diagram in the guide below. Secure and insulate all connections. Keep wires clear of pinch points when reassembling the base.


Illustrated guide and wiring diagram


The wiring diagram in this supplied guide is labeled “Gentoo schematic — Rev OD — October 2023.” If your wiring differs or you are unsure of the connections, email info@stainoutsystem.com with your sprayer model and clear photos before proceeding.


Stainout toggle-to-push-button switch installation guide: six steps and Gentoo wiring diagram


Replacement switch


 
 
 

Recent Posts

See All

Comments


bottom of page